I am a Dek

Comnav Pdf User Manuals. View online or download Comnav Installation And Operation Manual. ComNav Autopilot Manual. Autopilot System Installation & Operation Manual COMPLIES WITH CE REGULATIONS PN V ComNav Autopilot ComNav Autopilot. READ. Show more . Autopilot System Installation & Operation Manual v1r3 – ComNav ยท comnavmarine .

Author: Gardajinn Migis
Country: Indonesia
Language: English (Spanish)
Genre: Travel
Published (Last): 25 November 2013
Pages: 51
PDF File Size: 6.86 Mb
ePub File Size: 6.97 Mb
ISBN: 839-9-24471-178-9
Downloads: 11332
Price: Free* [*Free Regsitration Required]
Uploader: Brat

Make sure that it is sending information in the correct NMEA format. Enter a Waypoint into the navigation device. Make the joints watertight by using heat-shrink tubing and silicon, or some other watertight covering.

Insert the bared end of the wire into the terminal strip and fasten it there by tightening the screw on the terminal strip. Press and hold the Speed Key. Call your ComNav Dealer for service. The Autopilot is flashing the light above the Nav Key to warn you that your navigation information might not be correct.

There are two ways to connect the pump to the steering system. Outboard Feedback Caution The Outboard Feedback will be damaged if it is extended more than 10 inches. Refer to the Problems during the Setup Routine section, page You are now ready 14460 begin the Setup Routine. Do this before leaving the dock: Have a container ready to catch all excess oil.

  HOW TO CHANGE XFDL TO PDF

Comnav 1460

All information must be confirmed directly by the seller. Cross track error is a measure of the distance your boat has fallen away from the Course line. Turn the wheel cmnav the highest helm pump in both directions until no more fluid vomnav out of the lines.

Tighten the nuts on the watertight glands firmly with your hands. Parts for this are in the Accessory Kit. The Autopilot is not receiving any information from either a Fluxgate or a Magnetic Compass. Terminal strip J5 is located in the lower right side of the Processor circuit board see above.

Comnav – Safe Sea Shop

The rudder is not moving in response to the Autopilot. The Autopilot can also steer your vessel through a series of 146 which the navigation device has grouped together as a Route. To decrease the Sensitivity: Place the gland from the Accessory Kit in the drilled hole. Do not mount the Processor near heat sources, such as heat radiators, or over engines.

Note that the cannot be turned off from a Control Head which is not the active one.

Move your vessel to comnac location that is: The first method will usually be easier. Below is the list of the NMEA data sentences from which the Autopilot can obtain navigation data, and the order of priority in which the can use these sentences: When you have completed the bleeding, comnab the equipment for the bleeding procedure attached to your hydraulic steering system. This could be a GPS, plotter, or other device. Move the steering wheel to the mid-ships position After you press the Speed Key the Autopilot commnav do one of two things: Tighten the nuts on the watertight glands.

  KAAL SARP YOG MANTRA PDF

Radiated interference Section 4. However, this air will be expelled if the steering system is bled properly. Make sure that you and your passengers are braced for unexpected movement.

Then the light beneath the Green Key will begin to flash. Do not mount your Compass near any iron or steel objects. The first thing to check is your wiring and your navigation device.

comnqv To correctly position the Fluxgate Compass, mount it so that the top surface with the cable gland is up. Turn the Autopilot ON. Vessel turns to Port Rate of turn: